V Hair Styling & Nails - Shop Details

$129.99~~$129.99~~

Matte Gray LithiumFX Trimmer

Rated out of 5 based on 1 customer rating

USA-040368

The Limited Edition Matte Gray LithiumFX Cordless Lithium Ergonomic Trimmer is a sleek and comfortable professional styling tool. Provide your clients with precise close cuts and shaves using the titanium T-blade. The trimmer’s DC motor is powerful with a long-life ball bearing motor.

SKU: USA-040368 Category: Nail Polish

USA-040368

Before using the trimmer for the first time, charge continuously for 3 hours. Maximum battery capacity will only be reached after 3 charging and discharging cycles.
Make sure the switch on the trimmer is in the "O" (OFF) position. Connect the charging jack into the receptacle on the bottom of the trimmer. Plug the adapter into an electrical outlet that has the same voltage listed on the label affixed to the adapter. The charging indicator will light up and blink to indicate that the charging has begun. Charging is complete after 3 hours. User will see LED light has stopped blinking and is now solid.
The adapter may become warm while charging. This is normal.
Preserving the battery: In order to maintain the optimum capacity of the rechargeable battery, the trimmer should be recharged for 3 hours approximately every 6 months.
Make sure the switch is in the "O" (0FF) position when the trimmer is not operating.
Remove hair trimmings and debris from the blades using the provided cleaning brush. Wipe the housing clean with a dry cloth.
Apply a few drops of lubricating oil to the blades, and wipe off any excess oil with a dry cloth. This last procedure is important for the proper maintenance of the blades.
If the charging light starts to flash rapidly (more than 4 flashes per second), the appliance is faulty. If this happens, stop charging and remove the adapter from the outlet and contact an authorized service center.

ZERO GAP ADJUSTMENT TOOL
IMPORTANT! Only attempt to zero gap the blades by using the adjustment tool and following the instructions very precisely. The adjustment tool is required to adjust the blades to zero gap, which will achieve a closer, more precise cut.

Using the screwdriver included, gently loosen the two small screws on each side of the blade.
Slide the zero gap tool over the gold fixed blade until it is tight against the back portion of the moving cutting blade.
Using your fingers on each side of the zero gap tool, push up until the black cutting blade is even with or slightly below the gold fixed blade.

Black Titanium Tri-Blade (FX707B2) — Zero-Gap Adjustable
Long-Life Ball Bearing DC Motor — 6,800 RPM
Ergonomic-Grip Housing
Lithium-Ion Battery — Over 4 Hours of Cordless Runtime
LED Low-Battery Indicator
Universal Charging Port — FXCORD included
Limited 2 Year Warranty

Mark Jack
22 April, 2022
Rated 5.00 out of 5 based on 1 customer rating

Completely build enabled web-readiness and distributed customer service. Proactively customize.
Alexa Deo
26 April, 2022
Rated 5.00 out of 5 based on 1 customer rating

Completely build enabled web-readiness and distributed customer service. Proactively customize.
Tara sing
26 April, 2022
Rated 5.00 out of 5 based on 1 customer rating

Completely build enabled web-readiness and distributed customer service. Proactively customize.
Tara sing
26 April, 2022
Rated 5.00 out of 5 based on 1 customer rating

Completely build enabled web-readiness and distributed customer service. Proactively customize.